Multi Pro 5700 - Toro
Multi Pro 5700 - Toro
Multi Pro 5700 - Toro
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Disassembly (Fig. 47)<br />
1. Remove four (4) washer head screws that secure<br />
cover tube. Remove one (1) screw (item 1) that retains<br />
rear housing. Slide rear housing and housing gasket<br />
from assembly.<br />
2. Slide thin washer, intermediate gear, and thick washer<br />
from front housing support pin.<br />
3. In order, remove washer, clutch, woodruff key, and<br />
second washer from ball screw shaft.<br />
4. Pull cover tube from front housing. Remove cover<br />
tube gasket.<br />
5. Loosen and remove two (2) hex nuts that secure motor<br />
to front housing. Slide motor, motor gear, and motor<br />
seal from front housing.<br />
6. Remove ball screw and brake assembly from front<br />
housing.<br />
7. Clean actuator components. Replace worn or damaged<br />
parts.<br />
8. Discard and replace all removed gaskets and o–<br />
rings.<br />
Assembly (Fig. 47)<br />
1. Position ball screw and brake assembly to front<br />
housing. Take care to not disturb brake components.<br />
2. Slide motor, motor gear, and motor seal to front<br />
housing. Secure motor with two (2) hex nuts. Torque<br />
nuts to 70 in–lb (7.9 N–m).<br />
3. Install new o–rings into rear of cover tube. Slide cover<br />
tube gasket and cover tube over ball screw.<br />
4. Place washer on ball screw shaft. Position woodruff<br />
key and then slide clutch and second washer onto shaft.<br />
5. Place thick washer, intermediate gear, and thin<br />
washer onto front housing support pin. Make sure that<br />
intermediate gear engages both motor gear and clutch.<br />
6. Position housing gasket to front housing. Slide rear<br />
housing over gears.<br />
7. Secure rear housing:<br />
A. Thread one (1) screw (item 1) through rear housing<br />
and into front housing.<br />
B. Install four (4) washer head screws through cover<br />
tube.<br />
C. Torque screw (item 1) to 20 in–lb (2.3 N–m).<br />
Torque four washer head screws to 70 in–lb (7.9<br />
N–m).<br />
Spray<br />
System<br />
<strong>Multi</strong> <strong>Pro</strong> <strong>5700</strong>–D Page 6 – 45 Rev. A Spray System