Multi Pro 5700 - Toro

Adjustment
1. Loosen end nut that secures adjustable clevis to
boom frame (Fig. 45). Position jam nut as close as possible
to adjustable clevis. Tighten end nut to secure clevis.
2. Fully raise side boom with the boom actuator. The
boom actuator should fully extend and ratchet.
3. With the boom actuator at full extension, there
should be a gap of approximately .105” (2.7 mm) between
the breakaway pivot gusset and the center boom
frame slot (Fig. 46).
2
1
3
4
4. If needed, loosen end nut that secures adjustable
clevis and readjust jam nut on clevis to allow correct
boom actuator extension. Tighten end nut to secure clevis
adjustment.
Figure 45
1. Boom actuator 3. Jam nut
2. Adjustable clevis
4. End nut
1
2
3
Figure 46
1. Breakaway pivot gusset 3. Boom actuator
2. Boom frame slot
Spray
System
Multi Pro 5700–D Page 6 – 43 Rev. A Spray System