Multi Pro 5700 - Toro

Boom Actuator (Machines with Serial Numbers Below 260000000)
1
2
3
4
1
2
3
1. Cotter pin
2. Clevis pin
Removal (Fig 44)
Figure 44
3. Boom actuator 4. Wire harness
Installation (Fig 44)
1. Park machine on a level surface, lower booms, stop
engine, engage parking brake, and remove key from the
ignition switch.
2. Label actuator electrical leads to ease reassembly.
Unplug boom actuator connector wires from machine
harness.
3. Support boom to prevent it from falling. Remove cotter
pins and clevis pins that attach boom actuator to center
and side boom.
1. Position actuator to clevis attachment points on center
and side booms.
2. Install clevis pins and cotter pins to secure actuator
to boom assembly.
3. Plug actuator connector wires into machine harness.
Make sure that operator switches engage correct actuator.
4. Pull actuator from machine.
Spray System
Page 6 – 42
Rev. A Multi Pro 5700–D