Multi Pro 5700 - Toro

Assembly (Fig. 41)
1. If pivot bracket (item 11) was removed from machine,
lightly lubricate bushings (item 12) with motor oil before
assembly. Connect boom actuator (not shown) to pivot
bracket (see Boom Actuator Installation (Machines with
Serial Numbers Above 260000000) in this section).
2. Make sure that hinges (item 1) are securely fastened
to pivot bracket (item 11) and boom (item 5). The boom
hinge uses four (4) backing plates between the boom
and flange nuts.
3. Position boom hinge to pivot bracket hinge. Make
sure that rubber boots (item 2) are placed at hinge junctions
and that rib on boots are toward the top of the boom
(Fig. 42).
4. Insert two (2) cap screws (item 9) through flat washers
(item 10) and hinges. Place tube (item 17), breakaway
spring (item 19), spring retainer (item 18) and lock
nut (item 8) on each cap screw. Make sure that shoulder
on spring retainer fits into breakaway spring.
5. Tighten lock nuts so there is 1.560” (39.6 mm) between
the face of the spring retainer and the hinge casting
(Fig. 43).
6. Connect supply hose to tee fitting on spray boom and
secure with hose clamp.
7. Lubricate grease fittings on boom hinge (see Operator’s
Manual).
2
UP
Figure 42
1. Rubber boot 2. Rib
Figure 43
1
1.560”
(39.6 mm)
Spray
System
Multi Pro 5700–D Page 6 – 41 Rev. A Spray System