Multi Pro 5700 - Toro

Turret Body Service
Disassembly (Fig. 36)
1
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disassembly.
Wear protective clothing, chemical resistant
gloves, and eye protection during repair.
18
2
3
5
6
7
1. Pull e–clip from body and slide plug with o–ring from
body.
2. Disassemble turret body using Figure 36 as a guide.
17
4
8
9
10
3. Discard all removed seals, gaskets, o–rings, and diaphragms.
Assembly (Fig. 36)
16
15
14
13
6
11
NOTE: Coat all o–rings with vegetable oil before installation
to reduce the chance of damage during assembly.
12
1. Replace all removed seals, gaskets, o–rings, and diaphragms.
2. Assemble turret body using Figure 36 as a guide.
A. The turret (item 8) end with slightly larger bore
and detent grooves needs to be orientated toward
detent posts on body (item 4) (Fig. 37).
Figure 36
1. Upper clamp 10. Plug
2. O–ring 11. Nozzle
3. Pivot pin 12. Nozzle cap
4. Body 13. O–ring
5. E–clip 14. Seal
6. Gasket (3 used) 15. Screw
7. Dust cap (2 used) 16. End cap
8. Turret 17. Diaphragm
9. O–ring 18. Hose barb
B. Make sure to align notch on plug (item 10) with
groove in body (item 4) as plug is installed.
1
3
C. Install e–clip (item 5) into body to secure assembly.
2
Spray
System
2
Figure 37
1. Body 3. Detent groove
2. Detent post
Multi Pro 5700–D Page 6 – 37 Spray System