Multi Pro 5700 - Toro

Disassembly (Fig. 30)
IMPORTANT: Make sure to remove and neutralize
chemicals from tank and spray components before
disassembly. Wear protective clothing, chemical resistant
gloves, and eye protection during repair.
1. Park machine on a level surface, stop engine, engage
parking brake, and remove key from the ignition
switch.
Assembly (Fig. 30)
NOTE: Coat all o–rings with vegetable oil before installation
to reduce the chance of damage during assembly.
1. Assemble boom bypass using Figure 30 as a guide.
Replace all removed o–rings and gaskets.
2. Check spray tank for leaks.
2. Drain spray tank (see Operator’s Manual).
3. Disassemble boom bypass using Figure 30 as a
guide. Discard all removed o–rings and gaskets.
Spray
System
Multi Pro 5700–D Page 6 – 31 Spray System