Multi Pro 5700 - Toro

IMPORTANT: The agitation valve motor may have a
fuse for circuit protection. Make sure that correct
fuse is installed in the in -line fuse holder located in
the boom valve motor harness.
The agitation switch on the operator spray console is
used to energize the agitation valve motor and open the
valve. The open agitation valve allows system flow to
reach the three (3) agitation nozzles located in the spray
tank. Two (2) styles of agitation valve motors have been
used on Multi Pro 5700--D machines. Both of these motor
styles are shown in Figure 27.
1
SERIAL NUMBER BELOW 310000000
3
4
5
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disassembly.
Wear protective clothing, chemical resistant
gloves, and eye protection during repair.
Disassembly (Fig. 27)
1. Remove agitation valve motor assembly from machine
(see Spray Control Assembly in this section).
2. Disassemble agitation valve motor assembly as
needed using Figure 27 as a guide. Discard all removed
O--rings and gaskets.
2
1. Agitation valve motor
2. Agitation supply hose
3. LH boom valve motor
Figure 28
4. Center boom valve motor
5. RH boom valve motor
SERIAL NUMBER ABOVE 310000000
1
3
4
5
3. See Boom and Agitation Valve Motors in this section
for disassembly and assembly information of the agitation
valve motor.
Assembly (Fig. 27)
NOTE: Coat all O--rings with vegetable oil before installation
to reduce the chance of damage during assembly.
1. Assemble agitation valve motor assembly using Figure
27 as a guide. Replace all removed O--rings.
2. Install agitation valve motor assembly on machine
(see Spray Control Assembly in this section).
3. Operate spray system and check for leaks.
1. Agitation valve motor
2. Agitation supply hose
3. LH boom valve motor
2
Figure 29
4. Center boom valve moto
5. RH boom valve motor
Spray
System
Rev. D
Multi Pro 5700--D Page 6 - 25 Spray System