Multi Pro 5700 - Toro
Multi Pro 5700 - Toro
Multi Pro 5700 - Toro
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
4. If boom valve motor assembly is to be removed:<br />
A. Unplug machine wire harness connectors from<br />
boom valve motor(s).<br />
1<br />
SERIAL NUMBER BELOW 310000000<br />
4<br />
3<br />
5<br />
B. Remove pressure gauge tube from boom valve<br />
motor assembly.<br />
C. Remove fasteners that secure boom valve motors<br />
to mount bracket (Fig. 22 or 23).<br />
6<br />
2<br />
D. Remove boom valve motor assembly from machine.<br />
5. If agitation valve motor is to be removed:<br />
A. Unplug machine wire harness connectors from<br />
agitation valve motor.<br />
B. Remove fasteners that secure agitation valve<br />
motor to mount bracket (Fig. 22 or 23).<br />
C. Remove agitation valve motor from machine.<br />
6. Remove additional spray control components as required<br />
using Figure 20 as a guide. Discard all removed<br />
O--rings and gaskets.<br />
1. Agitation valve motor<br />
2. Agitation supply hose<br />
3. LH boom valve motor<br />
2<br />
6<br />
Figure 21<br />
4. Center boom valve motor<br />
5. RH boom valve motor<br />
6. Boom supply hose<br />
SERIAL NUMBER BELOW 310000000<br />
1<br />
6<br />
Assembly (Fig. 20)<br />
NOTE: Coat all O--rings with vegetable oil before installation<br />
to reduce the chance of damage during assembly.<br />
1. Install spray control components using Figure 20 as<br />
a guide. Replace all removed O--rings and gaskets.<br />
2. Position removed motor assembly to mount bracket<br />
and secure with fasteners removed during disassembly<br />
(Fig. 22 or 23).<br />
3. On machines with serial number below 310000000,<br />
secure support bracket to mount bracket with two (2)<br />
flange head screws and flange nuts.<br />
4. Install hoses to correct locations on spray control assembly<br />
(Fig. 21). Secure hoses with hose clamps.<br />
5. If removed, install pressure gauge tube to boom<br />
valve motor assembly.<br />
6. Plug machine wire harness connectors to valve motor(s).<br />
7. Operate spray system and check for leaks.<br />
1. Boom valve motors<br />
2. Agitation valve motor<br />
2<br />
3<br />
Figure 22<br />
4<br />
3<br />
3. Flange head screw<br />
4. Flange nut<br />
SERIAL NUMBER ABOVE 310000000<br />
4<br />
Spray<br />
System<br />
3<br />
1. Boom valve motors<br />
2. Agitation valve motor<br />
1<br />
Figure 23<br />
3<br />
3. Flange head screw<br />
4. Flange nut<br />
Rev. D<br />
<strong>Multi</strong> <strong>Pro</strong> <strong>5700</strong>--D Page 6 - 21 Spray System
Change language