Multi Pro 5700 - Toro

IMPORTANT: Make sure to remove and neutralize
chemicals from tank and other components before
disassembly. Wear protective clothing, chemical resistant
gloves, and eye protection during repair.
Disassembly (Fig. 14)
1. Park machine on a level surface, stop engine, engage
parking brake, and remove key from the ignition
switch.
2. Drain spray tank (see Operator’s Manual).
3. Label disconnected hoses for proper installation after
repairs are completed.
1
SERIAL NUMBER BELOW 310000000
2
4. Remove agitation nozzles as required using Figure
14 as a guide. Discard all removed O--rings and gaskets.
Figure 15
1. Agitation valve motor 2. Agitation supply hose
Assembly (Fig. 14)
NOTE: Coat all O--rings with vegetable oil before installation
to reduce the chance of damage during assembly.
1. Install agitation nozzles using Figure 14 as a guide.
Replace all removed O--rings and gaskets.
1
SERIAL NUMBER ABOVE 310000000
2. Check spray system for leaks.
2
Figure 16
1. Agitation valve motor 2. Agitation supply
Spray
System
Rev. D
Multi Pro 5700--D Page 6 - 17 Spray System