Multi Pro 5700 - Toro
Multi Pro 5700 - Toro
Multi Pro 5700 - Toro
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
General Information<br />
Precautions Concerning Chemicals Used in Spray System<br />
Chemicals can injure persons, animals, plants, soil, or<br />
other property. To eliminate environmental damage and<br />
personal injury:<br />
1. Select the proper chemical for the job.<br />
2. Carefully read the directions printed on the chemical<br />
manufacturer’s labels before handling chemicals. Instructions<br />
on chemical manufacturer’s container labels<br />
regarding mixing proportions should be read and strictly<br />
followed.<br />
4. Always wear protective clothing, chemical resistant<br />
gloves, eye protection, and other personal protective<br />
equipment as recommended by the chemical manufacturer.<br />
5. <strong>Pro</strong>perly dispose of chemical containers, unused<br />
chemicals, and chemical solution.<br />
3. Keep spray material away from skin. If spray material<br />
comes in contact with a person, wash it off immediately<br />
in accordance with manufacturer’s recommendations<br />
(container labels and Material Safety Data Sheets).<br />
Precautions for Removing or Adjusting Spray System Components<br />
1. Stop the vehicle and set the parking brake.<br />
2. Shut off the vehicle’s engine and remove the key<br />
from the ignition switch.<br />
3. Disengage all power and wait until all moving parts<br />
have stopped.<br />
4. Remove chemicals from pump, hoses, and other<br />
spray components. Thoroughly neutralize and rinse<br />
spray system before loosening or removing any spray<br />
system component(s).<br />
5. Make sure line pressure is relieved before loosening<br />
any system component.<br />
O -Ring Seal Kit<br />
Part Number: 106--4846<br />
The O--Ring Seal Kit includes an assortment of O--rings<br />
used for sealing spray control valves on machines with<br />
serial numbers below 310000000. It is recommended<br />
that O--rings be replaced every two (2) years or whenever<br />
a fitting is loosened.<br />
SPRAYER<br />
O -RING SEAL KIT<br />
PART NO. 106 -4846<br />
Spray<br />
System<br />
Figure 1<br />
<strong>Multi</strong> <strong>Pro</strong> <strong>5700</strong>--D Page 6 - 3 Rev. D<br />
Spray System