Multi Pro 5700 - Toro

Traction Speed Sensor
Removal (Fig. 45)
1. Locate speed sensor on right side wheel motor. Disconnect
speed sensor from machine wire harness.
2. Loosen lock nut and remove speed sensor from
wheel motor.
Installation (Fig. 45)
1. Thread lock nut fully onto speed sensor threads.
1
2
2. Center a wheel motor piston in the center of the sensor
port (see Sensor Port View in Fig. 46). Use a suitable
tool to feel when a motor piston is in the center of the
sensor port.
3. Lubricate O-ring and install onto sensor threads.
4. Thread sensor into port until sensor contacts piston.
Rotate motor output shaft one complete revolution to
make sure it rotates freely.
5. Turn sensor out (counter-clockwise) until angle between
sensor orientation grooves and motor centerline
is between 90 o and 93 o , then back out sensor one full
turn. Hold sensor at this position and torque lock nut
from 75 to 125 in-lb (8.5 to 14.1 N--m).
6. Plug speed sensor connector into machine wire harness.
1. Speed sensor
2. O -ring
3
Figure 45
3. RH wheel motor housing
4. Motor piston group
4
SENSOR PORT VIEW
Sensor Port
Piston
Sensor Port
Piston
Orientation
Grooves
Speed Sensor
Lock Nut
CORRECT
POSITION
INCORRECT
POSITION
SENSOR INSTALLATION
90 o to 93 o
Motor
Centerline
Piston
SENSOR SIDE VIEW
Orientation
Grooves
Figure 46
Electrical System
Page 5 - 28
Rev. C
Multi Pro 5700--D