Multi Pro 5700 - Toro

Master Boom (Foot) Switch
The master boom switch is located on the floorboard of
the machine (Fig. 29). This switch allows the machine
operator to control the operation of all boom sections using
one switch.
1
Testing
1. Locate switch and unplug wire harness connectors
from switch. Note wire connector location on switch.
2. The switch terminals are shown in Figure 30. Continuity
should exist between the common terminal and
only one of the side terminals. When the switch is depressed,
continuity should exist between the common
terminal and the other side terminal. Regardless of
switch position, there should never be continuity between
the two side terminals.
3. Reconnect the harness connectors to the switch after
testing.
Figure 29
1. Master boom switch
1
2 2
Figure 30
1. Common terminal 2. Side terminal
Electrical System Page 5 – 18 Multi Pro 5700–D