You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
5-3-1 Selection for speed <strong>com</strong>mand<br />
In Speed control, input contacts SPD1 and SPD2 can be used for selecting one of the two methods below<br />
for setting speed limits.<br />
(1) External Analog <strong>com</strong>mand (Default) : Analog signal is input from terminals SIN & AG (pins 26& 29 on<br />
CN1)<br />
(2) Internal speed <strong>com</strong>mand: Selection of Three presentable Limits according to the table below.<br />
.<br />
Input Contact SPD2 Input Contact SPD1<br />
0 0<br />
0 1<br />
1 0<br />
1 1<br />
Speed Command<br />
External analog <strong>com</strong>mand<br />
SIN(CN1-26)<br />
Internal speed <strong>com</strong>mand 1<br />
Sn201<br />
Internal speed <strong>com</strong>mand 2<br />
Sn202<br />
Internal speed <strong>com</strong>mand 3<br />
Sn203<br />
Control<br />
Mode<br />
Note: Input contacts status “1” (ON) and “0” (OFF).<br />
Please check 5-6-1 to set the required high /Low signal levels (PNP/NPN) selection.<br />
S<br />
Diagram below shows the external analog speed <strong>com</strong>mand wiring:<br />
Internal presetable speed limit parameters for speed <strong>com</strong>mand mode are listed below:<br />
These preset limits apply to both CW & CCW directions.<br />
Parameter Name Default Unit Setting range Control mode<br />
Sn201<br />
Sn202<br />
Sn203<br />
Internal speed<br />
<strong>com</strong>mand 1<br />
Internal speed<br />
<strong>com</strong>mand 2<br />
Internal speed<br />
<strong>com</strong>mand 3<br />
100<br />
200<br />
300<br />
rpm -3000~3000 S<br />
5-10
Change language