TM 3-4240-280-10

More documents

Recommendations

Info

2-6. M10A1 CANSTER REPLACEMENT CRITERIA (CONT) (9) If a blood agent threat, change fitter In accordance with the table below: M10A1 canister change criteria for COMBAT/SPECIAL UNITS only, by climate Climate Replacement Climate Description Intervals (Weeks)* Hot Hot-dry 52 Hot-humid 13 War Moderate 52 Cold Humid 52 *Filter elements that exceed these Intervals remain serviceable for TRADOC training activities only. (10) If no blood agent threat exist, change filter annually. (11) When directed by unit commander or unit NBC NCO. b. For all other units not listed In paragraph a above, the canister shall be replaced In a with a(1) through a.(5) and in addition, when notified of deployment. c. Turn in damaged or unusable canisters to your hazardous waste management office or Defense Reutilization and Marketing Office (DRMO). 2-64 Change 3
2-7. GENERAL. Section III. OPERATION UNDER USUAL CONDITIONS TM 3-4240-280-10 WARNING Do not expose your facepiece to temperatures above 120”F (48.89” C). If facepieca is exposed to temperatures above 120”F (48.89’’C), allow lens to cool below this temperature before flexing lens or stowing facepiece in carrier or lens may crack and leak. This section contains operator’s instructions to put on and use the mask and additionally authorized items under normal conditions. For operation under unusual conditions, see paragraph 2-20. 2-8. PUTTING ON YOUR FACEPIECE FOR FIT AND LEAK CHECK. NOTE A trained unit NBC NCO will supervise size selection and initial fitting of your facepiec-e. However, it’s your responsibility to make sure your facepiece fits properly, has a good seal, and is as comfortable as possible. 2-65
Page 1 and 2:
TM 3-4240-280-10 OPERATOR’S MANUA
Page 3 and 4:
WARNING (CONT) Canister insert filt
Page 5 and 6:
WARNING HEALTH/ENVIRONflE NTAL HAZA
Page 7 and 8:
TM 3-4240-280-10, 15 March 1988, is
Page 9:
2. File this change sheet In front
Page 13 and 14:
TABLE OF CONTENTS Page CHAPTER 1 IN
Page 15 and 16:
1-0
Page 17 and 18:
1-3. REPORTING EQUIPMENT IMPROVEMEN
Page 19 and 20:
1-6. DIFFERENCES BETWEEN MODELS. a.
Page 21 and 22:
CHAPTER 2 OPERATING INSTRUCTIONS Se
Page 23 and 24:
2-2. DESCRIPTION OF MASK (CONT). a.
Page 25 and 26:
2-2. b, DESCRIPTION OF MASK (CONT).
Page 27 and 28:
2-2. DESCRIPTION OF MASK (CONT). d.
Page 29 and 30:
2-2. e. DESCRIPTION OF MASK (CONT).
Page 31 and 32:
2-2. DESCRIPTION OF MASK (CONT). f.
Page 33 and 34:
2-2. DESCRIPTION OF MASK (CONT). h,
Page 35 and 36:
2-3. DESCRIPTION OF ADDITIONALLY AU
Page 37 and 38: 2-3. DESCRIPTION OF ADDITIONALLY AU
Page 39 and 40: 2-3. DESCRIPTION OF ADDITIONALLY AU
Page 41 and 42: 2-3. e. DESCRIPTION OF ADDITIONALLY
Page 43 and 44: 2-5. PREVENTIVE MAINTENANCE CHECKS
Page 45 and 46: 2-5. PREVENTIVE AINTIENANCE CHECKS
Page 55 and 56: 2-5. PREVENTIVE MAINTENANCE CHECK A
Page 59 and 60: 2-5. PREVENIVE UAINTENANCE CHECKS A
Page 69 and 70: 2-5. PREVENTIVE MAIN TENANC CHECKS
Page 77 and 78: 2-5. PREVENTIVE MAINTE NACE CHECK8
Page 87: TM 3-4240-280-10 2-6. M 10A1 CANIST
Page 91 and 92: TM 3-4240-280-10 c. Spread open the
Page 93 and 94: TM 3-4240-280-10 f. Using your fing
Page 95 and 96: TM 3-4240-280-10 NOTE Make sure mic
Page 97 and 98: TM 3-4240-280-10 NOTE Tha following
Page 99 and 100: TM 3-4240-280-10 2-75
Page 101 and 102: TM 3-4240-280-10 2-11. REMOVING YOU
Page 103 and 104: 2-13. PUTTING ON YOUR FACEPIECE, WI
Page 105 and 106: TM 3-4240-280-10 d. Pull open flap
Page 107 and 108: TM 3-4240-280-10 NOTE Always put yo
Page 109 and 110: TM 3-4240-280-10 i. Check your face
Page 111 and 112: TM 3-4240-280-10 2-87
Page 113 and 114: m. Pull slider(17) to tighten neck
Page 115 and 116: TM 3-4240-280-10 p. On M25A1 mask,
Page 119 and 120: TM 3-4240-280-10 d. Remove faCepieC
Page 123 and 124: TM 3-4240-280-10 d. Remove facepk?c
Page 125 and 126: TM 3-4240-280-10 2-16. STOWING YOUR
Page 127 and 128: TM 3-4240-280-10 e. Hold the top fr
Page 129 and 130: TM 3-4240-280-10 g. With your free
Page 131 and 132: TM 3-4240-280-10 b. Folding M9 Cani
Page 133 and 134: (3) (4) Adjust long straps (5) so t
Page 135 and 136: 2-18. WEARING YOUR CARRIER AND CANI
Page 137 and 138: TM 3-4240-280-10 2-113
Page 139 and 140:
(5) On the ABC-M5 hood only, temple
Page 141 and 142:
TM 3-4240-280-10 2-117
Page 143 and 144:
. Installing and Adjusting Your M8
Page 145 and 146:
TM 3-4240-280-10 (4) Plug male end
Page 147 and 148:
TM 3-4240-280-10 2-123
Page 149 and 150:
TM 3-4240-280-10 2-125
Page 151 and 152:
. Putting on Your Facepiece, With H
Page 153 and 154:
c. Removing Your Facepiece, With Ho
Page 155 and 156:
Section lll. MAINTENANCE PROCEDURES
Page 157 and 158:
TM 3-424O-28O-1O 3-3
Page 159 and 160:
TM 3-4240-280-10 (6) Clean and poli
Page 161 and 162:
TM 3-4240-280-10 (7) Using cleaning
Page 163 and 164:
APPENDIX A REFERENCES TM 3-4240-280
Page 165 and 166:
APPENDIX B TM 3-4240-280-10 COMPONE
Page 167 and 168:
Section Il. COMPONENTS OF END ITEM
Page 169 and 170:
APPENDIX C ADDITIONAL AUTHORIZATION
Page 171 and 172:
Section Il. ADDITIONAL AUTHORIZATIO
Page 173 and 174:
APPENDIX D TM 3-4240-280-10 EXPENDA
Page 175 and 176:
TM 3-4240-280-10 Section Il. EXPEND
Page 178:
TM 3-4240-280-10
show all

TM 3-4240-280-10

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?