Chapter 1 - Pacific Communications

User’s Manual
• Transaction Start: Enter the transaction start text string. The NVR system considers that a transaction
starts when the start text string is entered. If Any Character is enabled, you will not be able to enter a
text string, and the NVR system considers that a transaction starts when any text string is entered.
• Transaction End: Enter the transaction end text string. The NVR system considers that a transaction
ends when the end text string is entered. Select the number of additional text lines to be displayed after
the end of the transaction from the drop-down list.
• Line Delimiter: Enter the character(s) that the text-in product uses to indicate the end of a line. Special
characters can be created using ^ and a capital letter;e.g., ^J for NL (New Line), ^M for CR (Carriage
Return). Refer to the text-in product manufacturer’s user manual for Line Delimiter character(s).
• Ignore String: Enter any text strings to be ignored. Refer to the text-in product manufacturer’s user
manual for text strings that the text-in product sends during normal transactions so that those text strings
will not be considered as text-in.
• Case Sensitive: Check the box if text strings are case sensitive. Refer to the text-in product
manufacturer’s user manual to determine if the text strings are case sensitive. If the text-in product
distinguishes between upper and lower case letters, make certain this is enabled.
• Timeout: Set the length of time to wait for a new text string. The NVR system will consider a transaction
complete if no new text is entered during the time-out period after the last text input even though the
transaction end text string is not entered.
NOTE: The required settings may differ depending on the text-in product. Refer to the text-in product
manufacturer’s user manual for details about settings.
Event
It is supported only for devices which do not use the
SiRiS protocol and for which event related functions
are supported.
• Dwell Time (Seconds): The NVR system considers
the event detection complete if the established dwell
time has expired since the event detection is notified
from the device.
Changing Device’s Setting Remotely
Selecting Remote Setup Device from the device menu allows you to change the device’s settings remotely.
Changing the device’s settings remotely might not be available for some settings. If the device supports
more than one protocol, the settings for remote setup in the SiRiS program might be different depending
on the protocol in use. Refer to the device user manual for details about the settings. Refer to 11.3
Remote Setup of ONVIF TM Conformance Protocol Devices (p. 104) in this document for details about
remote setup of a device which uses the ONVIF TM Conformance protocol.
102