You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
EN 70<br />
9.<br />
<strong>LC7.1E</strong> PA<br />
Circuit Descriptions, Abbreviation List, and IC Data Sheets<br />
AUDIO CLASS D<br />
FLASH<br />
MEM<br />
MICRONAS<br />
AUDIO PROC.<br />
SDRAM<br />
DC-DC CONVERSION<br />
SDRAM<br />
H_16940_011.eps<br />
060307<br />
Figure 9-2 SSB bottom view<br />
9.2 PDP Power Supply<br />
The Power Supply Unit (PSU) in this chassis is a buy-in and is<br />
a black-box for Service. It belongs to the PDP and when<br />
defective, a new panel must be ordered and the defective panel<br />
must be returned for repair, unless one of the fuses of the unit<br />
is broken. Always replace the fuse with one of the correct<br />
specifications! This part is commonly available in the regular<br />
market. For the correct order number, refer to the SDI PDP<br />
Service Manual (order code see front page of this manual). The<br />
42” and 50” supply units have different specifications.<br />
Figure “Overview of PSU connectivity” shows the connectivity<br />
of the Power Supply Unit with the other panels in the set.<br />
Y & X<br />
Driving Board<br />
Logic &<br />
Address Buffer<br />
AC Inlet<br />
PSU<br />
SSB<br />
• +12 V and -12 V to Audio Supply (-AUDIO_POWER,<br />
+AUDIO_POWER).<br />
• + 5 V switch voltage (+5V+SW).<br />
• +5.2 V standby voltage (+5V_STANDBY).<br />
9.3 DC/DC converters<br />
A switch generates the +5.2 V (+5V_SW) from the +5.2 V<br />
(+5V_STANDBY) supply voltage. For LCD sets, this switch is<br />
mounted on-board the SSB. For PDP sets, this switch is<br />
mounted on the Power Supply Panel. This results in the<br />
+5V_STANDBY (and +5V_SW for PDP sets) voltage(s),<br />
coming from the Power Supply Unit, is (are) used as input for<br />
the on-board DC/DC converters.<br />
They deliver the following voltages to the board:<br />
• +3.3 V (+3V3_STBY)<br />
• +5.2 V (+5V_SW) (only for LCD sets)<br />
• +1.8 V (+1V8S_SW)<br />
• +34 V (+VTUN)<br />
• +3.3 V (+3V3_SW)<br />
• +3.3 V (+3V3_MOJO)<br />
• +1.2 V (+1V2_MOJO)<br />
An overview can be found in figure “DC-DC converter block<br />
diagram”.<br />
H_16960_013.eps<br />
050407<br />
Figure 9-3 Overview of PSU connectivity<br />
All Power Supply Units deliver the following voltages / signals<br />
to the chassis:<br />
• +12 V to SSB (+12V_DISP).