ISPSoft User Manual

ISPSoft User Manual
*. Please refer to section 3.4 for more information about the setting of parameters in a module. Please refer to
programming manuals for more information about the instruction FROM/TO.
The Input/Output Device Range column on the information list can be defined not only by the
system, but also by users. Users can click a cell on the information list, and then click , or type a
start address directly. After the Manual Assignment window appears, the users can type a start
address, and click OK.
Devices that users assign to a module so that the data in the module can be stored can not overlap
data registers that the users assign to a module so that the parameters in the module can be stored.
If a device address typed conflicts with another device address, the system will modify the device
address which is typed, and provide a device address which can be used. For example, if users
want to assign D3000 which has been assigned to a module to another module, the system will
provide a device address which can be used.
After the input/output device addresses assigned to a module are changed, the input/output device
addresses assigned to a module added will follow the new input/output device addresses assigned
to the preceding module, and the input/output device addresses which have been assigned will be
skipped. Even if the new input/output device addresses assigned to the preceding module are not
the largest addresses, the input/output device addresses assigned to the module added will follow
the new input/output devices addresses.
Please refer to the following example. The input device addresses assigned to AH04AD-5A installed
in slot 2 is changed to D50~D57.
3-15