ISPSoft User Manual

Chapter 2 Starting and Setting
2.4.3.3 Setting Communication Parameters for DirectLink (USB)
(1) Users can type a driver name in the Driver Name box. Special marks can not be used except
_.
(2) Select DirectLink (USB) in the Type drop-down list box in the Connection Setup section.
(3) Users can select the number of times the sending of a command is retried if a connection error
occurs in the Time of Auto-retry box, and select an interval of retrying the sending of a
command in the Time Interval of Auto-retry box.
2.4.3.4 Setting Communication Parameters for Ethernet
(1) Users can type a driver name in the Driver Name box. Special marks can not be used except
_.
(2) Select Ethernet (USB) in the Type drop-down list box in the Connection Setup section.
(3) Select a network interface card in the Description drop-down list box. An IP address assigned
to a network interface card selected is displayed in the lower left corner of the Ethernet Card
section.
(4) Owing to the characteristics of Ethernet, a computer can communicate with all devices on a
network. Users can create the IP addresses of devices connected to this driver in the IP
Address Setting section.
‣ Some devices support the Search function. After users click Search to search for IP
addresses, results are displayed in the IP Address Setting section.
‣ After users click Add to add a new IP address to the list of IP addresses in the IP Address
Setting section, they can type related information in the IP Address section, the Port
Number column, and the Comment column.
Users can type the IP address of a device connected in this column.
Users can type a communication port number specified. If it is not necessary to specify a
2-41