ISPSoft User Manual

Chapter 16 Network Configuration and Data Exchange
Additional remark
(a) If the devices selected do not conform to the principle described in (1), the system will not
connect the devices selected to a new network, and a warning message will appear.
(b) If a device selected has more than one port which is not connected to any network and matches
the new network added, the system will connect the port whose port number is smaller to the
new network added.
(c) Users can select multiple devices by dragging a selection net around them. If the users press
Ctrl+A on the keyboard, all the devices and networks in the working area are selected.
(d) If users select a node which consists of a PLC and a module, and the PLC and the module
conform to the principle described in (1), the system will connect a port of the PLC and a port of
the module to a new network added.
(e) If the devices that users select have ports which are not connected to any networks, and can be
connected to an RS-485 network or an Ethernet network, the system will connect the ports to an
Ethernet network.
16.2.3 Adjusting or Deleting Devices or Networks
• Adjusting the order in which the nodes in the working area are arranged
Users can change the order in which the nodes in the working area are arranged by dragging a
node to a different position. The nodes in the working area can only be at the same level, and
increase rightwards. The users can not drag a node to a position above or under another node.
16-20