ISPSoft User Manual

Chapter 16 Network Configuration and Data Exchange
under the existing network.
The users move the mouse cursor to the existing network while holding the left mouse button
down. If the network matches the port, the port will connect to the network after the users release
the left mouse button.
If the users move the mouse cursor to the dotted line while holding the left mouse button down,
the port will connect to a network which matches the port.
• Connecting a single device or several devices to an existing network
(1) The users hold down Shift on the keyboard while they click devices and a network. They
have to conform to the two principles below.
(a) PLCs and modules are independent devices. A device that the users click must have at
least one port which is not connected to any network, and matches the network clicked.
(b) The users can click several devices, but they can only click one network.
(2) After the users click Connect Devices on the Edit menu, or on the toolbar, the system
will connect the devices clicked to the network clicked.
16-18