ISPSoft User Manual

ISPSoft User Manual
13.1 Editing Tools and Auxiliary Functions in ISPSoft
13.1.1 Changing the PLC Type
Users are allowed to change the PLC type in ISPSoft. Users have to pay attention to the following
two points before they change the PLC type.
(a) An AH500 system is not compatible with a DVP system, and therefore users can not change
the model from an AH500 series CPU module to a DVP series PLC.
(b) If the PLC type is changed, the functions, the range of devices, and the instructions supported
may be changed. After the PLC type is changed, users have to check whether the original
program, parameter setting, hardware configuration, and network configuration can make the
system operate normally.
If users want to change the PLC type, they can click Change PLC Type… on the Tools menu,
select a PLC type in the Change PLC Type window, and click OK.
13.1.2 Downloading/Uploading a Project
Users can download/upload not only the program in a project, but also the functions or the
parameters in the project.
If users want to download the project, they can click the PLC menu, point to Transfer, and click
Download. The users can also download the project by clicking on the toolbar. Select the
items which will be downloaded in the Transfer Setup window, and then click OK.
If users want to upload the project, they can click the PLC menu, point to Transfer, and click Upload.
The users can also upload the project by clicking on the toolbar. Select the items which will be
uploaded in the Transfer Setup window, and then click OK.
13-2