ISPSoft User Manual

ISPSoft User Manual
inlet will be in the outlet, and the clamp from which the plate made its exit will receive another plate.
During the whole process, a plate enters the inlet independently, and the plate in the outlet makes its
exit from the outlet independently. However, the rotator does not rotate independently.
When the system begins to operate, the cylinders under the clamps open the clamps. After the
clamps are opened, the system will send readiness signals. After the readiness signals are sent, a
plate will enter the inlet, and the plate in the outlet will make its exit from the outlet.
After a plate enters the inlet, and the plate in the outlet makes its exit from the outlet, the system will
receive completion signals, the corresponding readiness signals will be set to OFF, and the clamps
will be closed. After the system makes sure that the clamps are closed, the system will send a
trigger signal. After the rotator rotates 180 degrees, and the system receives a completion signal,
the next cycle will begin.
12-32