ISPSoft User Manual

Chapter 2 Starting and Setting
In the New Motion Module window, type a file name in the File Name box, select a model in the
Type drop-down list box, and select a slot number in the Slot No. drop-down list box according to
the hardware configuration carried out through HWCONFIG. Every slot number corresponds to a
PMSoft project. If a slot number is not set, or if users want to change a slot number later, users
can select Undefined in the Slot No. drop-down list box. After the setting is complete, users can
click OK.
*. Please refer to chapter 3 for more information about HWCONFIG.
• Developing a PMSoft project
If users want to edit a project for a motion control module which has been created, they have to
double-click the project to start PMSoft. The users can write a program for the motion control
module in PMSoft.
However, if users do not specify a slot for a motion control module, they are not allowed to edit the
project for the motion control module.
2-27