ISPSoft User Manual

ISPSoft User Manual
Incorrect example
Description
The value of a symbol whose data type is TIMER can not
be sent to a symbol whose data type is DWORD, but can
be sent to a symbol whose data type is WORD.
The value in a HC device can not be sent to a symbol
whose data type is WORD, but can be sent to a symbol
whose data type is DWORD.
The multiple output nodes must conform to the rules listed
above. The example is incorrect because the data length
of the output node representing a symbol whose data type
is INT is less than the data length of the input node.
• Inserting an output node
(1) Select a position into which an output node will be inserted in the working area. Users are
allowed to insert output nodes into the positions marked with red frames in the figure below.
(2) In addition to the structure in the figure above, users may be allowed to insert an output node
into another structure. If users are allowed to insert an output node into the position selected,
on the toolbar can be clicked. After is clicked, an output node will be inserted.
An output node can be inserted in the following structures.
Inserting an output node into an input pin of an AND/OR block
Before
After
9-8