ISPSoft User Manual

ISPSoft User Manual
declared for them.
• The program in the COUNTING is not related to the other programs except that the operation flag
and the completion flag are related to the other programs. In other words, the COUNTING is quite
independent. In order to make the program in the COUNTING more readable, the program is
created in a function block.
7.4.2 Creating the Program
Users can directly modify the program created in section 6.3, or write the program shown in section
6.3 again. If the users want to write the program again, they have to create a new project, and refer
to chapter 4~chapter 6 for more information.
Please refer to section 5.4.1, and create EQUIP_TRIG in the Function Blocks section in the project
management area.
The program in EQUIP_TRIG functions to inject the glue. Please refer to section 6.2.2, and create
the two symbols shown below in the local symbol table in the EQUIP_TRIG window. Please refer to
chapter 4~chapter 6, and write the program shown below.
Create PARTS_CNT in the Function Blocks section in the project management area.
The program in PARTS_CNT functions to count the parts which are conveyed. Please refer to
section 6.2.2, and create the three symbols shown below in the local symbol table in the
PARTS_CNT window. The initial value of CNT_DT is 0. Please refer to chapter 4~chapter 6, and
write the program shown below.
7-24