ISPSoft User Manual

ISPSoft User Manual
Icon Keyboard shortcut Function
Shift+Ctrl+C
None
Shift+Ctrl+A
Shift+Ctrl+B
Shift+Ctrl+P
Shift+Ctrl+N
Ctrl+I
Shift+Ctrl+I
ESC
Typing an instruction
Typing an instruction
Typing an instruction
Typing an instruction
Typing an instruction
Typing an instruction
Shift+Ctrl+U
Displaying/Hiding the comments on the networks
Displaying/Hiding the commands on the devices
Activating/Inactivating the network selected
Adding a bookmark to the network selected or
deleting a bookmark from the network selected
Going to the previous bookmarked position
Going to the next bookmarked position
Putting a network above the network selected
Putting a network under the network selected
Selection
Inserting a contact
Inserting a coil
Inserting a comparison contact
Selecting a type of comparison contact
Inserting a block logic instruction
(NP/PN/INV/FB_NP/FB_PN)
Selecting a type of block logic instruction
(NP/PN/INV/FB_NP/FB_PN)
Inserting an instruction or a function block
*. Please refer to section 4.5.3 for more information about typing an instruction.
4.5.2 Basic Editing─
Creating a Contact and a Coil
(1) Click on the toolbar, and then move the mouse cursor to the red frame in network 1. The
mouse cursor appears as a contact when the mouse cursor is moved to the left side of the red
frame, the right side of the red frame, or the bottom of the red frame. Users can decide where
to insert a contact. If a ladder diagram is edited, the mouse cursor must be near a position
which is edited. Besides, an object inserted is arranged by the system automatically. Users
can not move the object at will.
In this example, users do not need to decide where to insert the contact. Therefore, the mouse
cursor can be near the red frame, and the users can click the left mouse button.
4-10