ISPSoft User Manual

ISPSoft User Manual
different from the actual hardware configuration.
Next, I/O Scan is clicked. The scan result will be the same as the actual hardware configuration.
After AH16AN01R-5A (installed in slot 1) is double-clicked to open the Parameter Setting window,
users will find that the parameter in the module is assigned the default value. The value of the
parameter is different from the value of the parameter previously downloaded to the CPU module,
that is to say, only the hardware configuration will be scanned after I/O Scan is clicked.
Then, Upload is clicked. After the uploading is complete, users will find that the hardware
configuration and the parameters in the modules which are uploaded are the same as the hardware
configuration and the parameters in the modules which were previously downloaded to the CPU
module. In other words, after Upload is clicked, the system parameters in the CPU module will read,
and the actual hardware configuration will not be uploaded.
Next, I/O Scan is clicked, and the scan result is downloaded to the CPU module. The BUS FAULT
LED indicator on the CPU module will be OFF, that is to say, the hardware configuration in the CPU
module is the same as the actual hardware configuration.
3.5.6 Online Diagnosis
Users not only can configure modules in HWCONFIG offline, but also can operate and inspect the
system through the Online Mode function if ISPSoft is connected to the CPU module. Owing to the
fact that HWCONFIG adopts the communication setting in ISPSoft, users have to make sure that
ISPSoft is connected to the CPU module normally before the Online Mode function is enabled.
Please refer to section 2.4 for more information about communication setting. If users want to
enable the Online Mode function, but the name of the CPU module is different from the name
attached to the model in the project management area, the system will remind the users to check
the name of the CPU module and the name attached to the model in the project management area.
Please refer to section 3.3.2.1 for more information.
3.5.6.1 Online Mode
(1) After users click Online Mode on the Option menu, or on the toolbar, the hardware
configuration will be in the online mode. If the users click
configuration will not be in the online mode.
again, the hardware
3-67