ISPSoft User Manual

ISPSoft User Manual
(5) After all the setting is complete, users can click OK to create the trigger.
*. The parameters set in HWCONFIG must be downloaded to the CPU module so that they can take effect. (Please
refer to section 3.3.6 or section 3.5.4 for more information.)
3.3.5.5 Ethernet─Advance: Email and Trigger Configuration
After users click the Ethernet─Advance tab at the top of the window, and the Email and Trigger
Configuration tab at the bottom of the window, they can set the relation between triggers for the
sending of emails and receivers. Before setting the function here, the users have to click the Email
tab, select the Enable Email Sending Function checkbox, click the Email Trigger tab, and set at
least one trigger. Please refer to section 3.3.5.3 and section 3.3.5.4 for more information.
First, type the email addresses of receivers in the Email Address column. Eight email addresses at
most can be set for the CPU module, and every email address is composed of sixty-four characters
at most. Then, select triggers corresponding to receivers. If email addresses or triggers are not set,
the corresponding selection positions are gray.
For example, if the condition represented by trigger 1 or the condition represented by trigger 4 is met,
the system will automatically send the emails to user_1@delta.com.tw. If the condition represented
by trigger 2 or the condition represented by trigger 5 is met, the system will automatically send the
email to user_2@delta.com.tw. If the condition represented by trigger 1 is met, the system will
3-49