Hydronic 10 (Water Heater) - Parts Manuals
Hydronic 10 (Water Heater) - Parts Manuals
Hydronic 10 (Water Heater) - Parts Manuals
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
9<br />
Fuel System<br />
The <strong>Hydronic</strong> <strong>10</strong> boxed unit is most commonly provided with<br />
the fuel metering pump mounted inside the box. This is to<br />
reduce installation time and to protect the pump from corrosion.<br />
If specifications cannot be met the pump must be mounted<br />
externally. See illustration for connections and specifications.<br />
All parts necessary to do the installation are included in the kit<br />
as shown.<br />
Note:<br />
Butt joints and clamps on all connections.<br />
N o t e :<br />
Fuel line limits must not be exceeded.<br />
Ensure that the following conditions are met.<br />
Bottom of the fuel metering pump must be within<br />
a height of 2’6” of the bottom of the fuel pick-up pipe.<br />
Fuel metering pump must be within a total<br />
distance of 6’6” from the fuel pick-up pipe.<br />
Fuel System Tolerances<br />
1. Fuel Pick-Up Pipe<br />
2. 11mm Clamp<br />
3. 5.0mm Fuel Line<br />
4. Fuel Metering Pump<br />
5. 9mm Clamp<br />
6. 3.5mm Rubber Connector<br />
7. 2.0mm White Plastic Fuel Line<br />
Fuel Line<br />
• Route fuel lines from the fuel pick-up pipe to the heater.<br />
• Use fuel lines provided.<br />
• Other sizes or types of fuel lines may inhibit proper fuel flow.<br />
• Make proper butt joints using clamps and connector pieces<br />
as shown<br />
• Use a sharp utility knife to cut plastic fuel lines to avoid<br />
b u r r s .