LEEP System 1000® Workstation Operating ... - CooperSurgical

LEEP System 1000 ® Electrosurgical
Generator Control Panel
LEEP Cart
To the outlet
LEEP System 1000
Electrosurgical Generator
(A)
(B)
Pivot Hinge
Door
Smoke Evacuator
Locking Caster (wheel)
(1 of 2)
Insert two screws in each hinge
Figure 1
2.2 Unpacking and Installing the Smoke Evacuator (box #2)
Required Tools: Phillips Screwdriver
After unpacking the Smoke Evacuator box,
1. Remove the screws on the base of the Cart in preparation for attaching the Smoke Evacuator.
2. Then align the pivot hinges on the Smoke Evacuator with the screw holes on the Cart itself and fasten
the Smoke Evacuator to the Cart. Make sure that the screws are tight, but DO NOT OVERTIGHTEN.
3. Remove the screws on the side of the Smoke Evacuator and then fasten down the bracket of the drop hinge
to the Smoke Evacuator. See Figure 1.
NOTE: The Smoke Evacuator Controls are located at the top front of the LEEP Cart for easy access.
4. Install the Electrosurgical Generator next.
2.3 Unpacking and Installing the LEEP System 1000 ® Electrosurgical Generator (box #3)
After unpacking the Electrosurgical Generator box, align the pins on the bottom of the Electrosurgical Generator
with the corresponding holes located on the top of the Cart. See Figure 1.
Face the Electrosurgical Generator toward the front of the Cart (where the door is) and drop the cord through the
rectangular cutout located at the top of the Cart. Do not hook up this cord until you have installed the filter and
tubing in the Smoke Evacuator.
LEEP System 1000 ® Workstation • Operating Manual
3