Chip Blaster manual - Salvex
Chip Blaster manual - Salvex
Chip Blaster manual - Salvex
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Chip</strong>BLASTER, Inc. 35<br />
14.0. PREVENTATIVE MAINTENANCE (Cont.):<br />
14.14. DUAL MANUAL FILTER: (CHIPBLASTER SHUT DOWN)<br />
The preferred method is to shut down the <strong>Chip</strong>BLASTER.<br />
14.14.1. A flashing red light will indicate when the bag filter is dirty.<br />
14.14.2. Open the air bleed valve to remove any pressure from the housing.<br />
Then remove the filter lid.<br />
14.14.3. Remove lid and inspect for damage. Be careful not to damage<br />
filter hold down plate, seal or springs. Set lid aside.<br />
14.14.4. Remove optional hydrocyclonic filter (if used) from center of bag.<br />
14.14.5. Pull the filter bag out of the housing.<br />
14.14.6. Install the new filter bag in the housing insure it is all the way<br />
down.<br />
14.14.7. Replace the optional hydrocyclonic filter (if used).<br />
14.14.8. Inspect the O-ring for cracks or tears, replace if damaged.<br />
14.14.9. Inspect filter hold down seal for cracks or tears, replace if damaged.<br />
14.14.10. Replace the filter lid. Make sure the O-ring is in the proper groove<br />
before replacing the lid. Replace the filter lid by setting straight down so<br />
that the filter hold down plate will contact filter bag.<br />
14.14.11. Torque filter lid cap screws to 30 FT LB (41Nm) in a star pattern.<br />
14.14.12. Refer to SECTION 11 START UP FOR FILTER PURGE.<br />
DO NOT POKE HOLES IN FILTER BAG WHEN CHANGING.<br />
DO NOT DUMP COOLANT FROM FILTER BAGS INTO<br />
<strong>Chip</strong>BLASTER TANK – DUMP COOLANT INTO MACHINE TOOL SUMP.<br />
DO NOT REUSE DIRTY FILTER BAGS.<br />
14.13–14.14<br />
Handle at “RUN FILTER “A”<br />
Handle at “RUN FILTER “B”