Chip Blaster manual - Salvex
Chip Blaster manual - Salvex
Chip Blaster manual - Salvex
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Chip</strong>BLASTER, Inc. 34<br />
14.0. PREVENTATIVE MAINTENANCE (Cont.):<br />
14.13. FILTER CHANGING PROCEDURE:<br />
USE CARE WHEN CHANGING FILTER BAGS AS THEY MAY BE<br />
HEAVY DEPENDING ON MATERIAL BEING MACHINED. THE USE OF<br />
GLOVES AND SAFETY GLASSES IS STRONGLY RECOMMENDED DO<br />
TO THE CHIPS THAT MAY BE IN THE FILTERS.<br />
DO NOT POKE HOLES IN FILTER BAG WHEN CHANGING.<br />
DO NOT DUMP COOLANT FROM FILTER BAGS INTO <strong>Chip</strong>BLASTER TANK<br />
– DUMP COOLANT INTO MACHINE TOOL SUMP.<br />
DO NOT REUSE DIRTY FILTER BAGS.<br />
14.0. PREVENTATIVE MAINTENANCE (Cont.):<br />
14.13.1. SINGLE FILTER:<br />
14.13.1.1. A flashing red light will indicate when the bag filter is dirty.<br />
!<br />
WHEN RUNNING A SINGLE FILTER THE SYSTEM MUST BE TURNED<br />
OFF BEFORE CHANGING THE FILTER.<br />
14.13.1.2. Open the air bleed valve to remove any pressure from the filter housing. Then<br />
remove the filter lid.<br />
14.13.1.3. Remove lid and inspect for damage. Be careful not to damage filter hold<br />
down plate, seal or springs. Set lid aside.<br />
14.13.1.4. Remove optional hydrocyclonic filter (if used) from center of filter bag.<br />
14.13.1.5. Pull the filter bag out of the housing.<br />
14.13.1.6. Install the new filter bag in the housing insure it is all the way down.<br />
14.13.1.6.Install optional hydrocyclonic filter (if used) into the center of filter<br />
bag.<br />
14.13.1.7. Inspect the O-ring for cracks or tears, replace if damaged.<br />
14.13.1.8. Inspect filter hold down seal for cracks or tears, replace if damaged.<br />
14.13.1.9. Make sure the O-ring is in the proper groove before replacing the lid.<br />
Replace the filter lid by setting straight down so that the filter hold<br />
down plate will contact filter bag.<br />
14.13.1.10. Torque filter lid cap screws to 30 FT LB (41Nm) in a star pattern.<br />
14.13.1.11. Refer to SECTION 11 START UP FOR FILTER PURGE.<br />
14.13