Chip Blaster manual - Salvex
Chip Blaster manual - Salvex
Chip Blaster manual - Salvex
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Chip</strong>BLASTER, Inc. 30<br />
14.0. PREVENTATIVE MAINTENANCE (Cont.):<br />
14.3. OIL CHANGE PROCEDURE:<br />
IT IS EXTREMELY IMPORTANT TO DISCONNECT AND LOCKOUT<br />
ANY AND ALL POWER SOURCES BEFORE ANY WORK IS TO BE<br />
PERFORMED ON the <strong>Chip</strong>BLASTER UNIT.<br />
14.3.1. <strong>Chip</strong>BLASTER High-Pressure Pump: Change the crankcase oil every<br />
2000 hours.<br />
USE:<br />
For <strong>Chip</strong>BLASTER Inc. pump 2106 - Mobil 1 fully-synthetic 15W-50.<br />
!<br />
FAILURE TO USE<br />
MOBIL 1 FULLY-SYNTHETIC 15W-50 WILL<br />
VOID YOUR WARRANTY<br />
Other Pumps and Motors: All have sealed bearings, no lubrication is necessary.<br />
14.3.2. Oil Change Procedure.<br />
14. 3.2.1 <strong>Chip</strong><strong>Blaster</strong> High Pressure pump: Change the crankcase oil<br />
every 2000 hrs.<br />
14.3.2.2. Remove accesses panel (use 6mm hex wrench).<br />
Typical access panel<br />
14.3.2.3. Locate OIL SIGHT GAUGE ASSEMBLY and remove plug.<br />
(use 8mm hex wrench). Allow to drain into a container. For a<br />
single pump unit there will be 32 ounces (0.9 liters) for a two<br />
pump unit there will be 64 ounces (1.9 liters). NOTE: In a two<br />
pump unit both pumps will be drained at the same time.<br />
DRAIN<br />
PLUG<br />
LOCATION<br />
14.3