Chip Blaster manual - Salvex
Chip Blaster manual - Salvex
Chip Blaster manual - Salvex
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Chip</strong>BLASTER, Inc. 17<br />
7.0. PLACING A <strong>Chip</strong>BLASTER:<br />
7.1. After you receive your new <strong>Chip</strong>BLASTER unit the first thing you need to do is prepare<br />
the site where you would like to place the unit.<br />
!<br />
INSTALLATION SITE MUST BE FLAT AND LEVEL.<br />
7.1.1. You need to keep the unit within 10’ of the machining center that you are<br />
connecting the <strong>Chip</strong>BLASTER to.<br />
7.1.2. Locate the unit so the <strong>Chip</strong>BLASTER’s electrical cabinet is within 15’ of the<br />
machining center’s electrical cabinet.<br />
7.1.3. Make sure you place the unit so maintenance can easily get to the filter housing<br />
and electrical cabinet on the <strong>Chip</strong>BLASTER unit. Refer to footprint drawing<br />
(Section 23) for recommended clearances.<br />
7.2. After you have the site cleared for the <strong>Chip</strong>BLASTER unit you are ready to prepare the<br />
<strong>Chip</strong>BLASTER.<br />
7.2.1. Remove the lumber that is used to hold the unit in place during transporation using<br />
a phillips screw driver or an electric screw gun.<br />
7.2.2. Before you remove the <strong>Chip</strong>BLASTER from the skid take a moment and remove<br />
the lid from the top of the <strong>Chip</strong>BLASTER unit. Remove the bag containing the<br />
leveling feet.<br />
7.2.3. When removing the <strong>Chip</strong>BLASTER only from the opposite end of the electrical<br />
enclosure.<br />
7.2.4. Insure the forks extend completely under the <strong>Chip</strong>BLASTER unit to the support.<br />
!<br />
DO NOT AT ANY TIME REACH UNDER THE <strong>Chip</strong>BLASTER UNIT<br />
OR STAND UNDER THE <strong>Chip</strong>BLASTER UNIT WHILE IT IS<br />
SUPPORTED BY A FORK TRUCK. IF YOU MUST REACH UNDER<br />
THE MACHINE BLOCK IT UP FOR SAFETY.<br />
7.2.5. The EV units are shipped from the factory with leveling feet as shown in figure<br />
1a. The leveling feet must be installed when setting up the <strong>Chip</strong>BLASTER.<br />
7.2.8. After you remove the <strong>Chip</strong>BLASTER from the skid take the set of four feet<br />
and install the studs of the leveling feet through the holes in the legs. Block unit<br />
while installing feet for safety. Reference; top of foot to the bottom of second nut<br />
(1”). The feet have two functions the first being to level the <strong>Chip</strong>BLASTER unit<br />
and the second being to help eliminate the transfer of noise. Refer to figure 1.<br />
7.2.9. After you have the feet in place proceed with moving the <strong>Chip</strong>BLASTER<br />
into place.