Chip Blaster manual - Salvex

ChipBLASTER, Inc. 100
27.0. OPTIONAL EQUIPMENT (Cont.):
27.1. Magelis Human Interface Unit (HMI) (Cont.)
27.1.7.12. To access the “Super Users Group” press the RIGHT ARROW key
and the FAULT RESET/PURGE pushbutton at the same time.
27.1.8. Pass fault memory clear and pass fault counter timer clear.
27.1.8.1. The past fault data may be cleared by pressing the DOWN ARROW
key and the FAULT RESET/PURGE pushbutton at the same time.
NOTE: this will only clear the fault memory not the machine run timer
data.
27.1.9. The Magelis HMI may be field installed by cutting the mounting hole in the door
of the control enclosure, mounting the HMI, plugging in the communication
adapter module to the PLC , plugging in the communications cable into the PLC
and the HMI. PLEASE CONTACT ChipBLASTER to order the preprogrammed
HMI and associated components.
NOTE: IF THE COOLANT SYSTEM IS STARTED WHILE IN EITHER OF THE PASS
FAULT SCREEN OR TOTAL FAULTS SCREEN THE SCREEN BEING
DISPLAYED WILL CHANGE TO ONE OF THE RUN STATUS SCREENS
DEPENDING ON THE ACTUAL OPERATING CONDITION.
At this time the LEFT ARROW and UP ARROW keys are not used.
27.1