All markets - Selecon

PL1 LED Luminaires
Installation & User’s Manual
WARNING! Disassembly (other than as described herein), alterations, unauthorized service, etc. will void the
product warranty. Contact your local Philips Selecon office or an Authorized Service Center for technical support and
service.
4. Accessories
Only Philips Selecon approved accessories should be used with your PL1 LED Luminaire. For a list of available
accessories from Philips Selecon, please see "ACCESSORIES" on page 4. For questions regarding accessories,
please contact your local Authorized Philips Selecon Dealer or Philips Selecon office.
To install diffuser or barndoor on a PL1 LED luminaire:
Step 1. Lower intensity of PL1 luminaire to no output.
WARNING! Using a prying device (such as a screwdriver) can damage locking mechanism. It is designed to be
unlatched by hand.
Step 2. At luminaire head assembly, as shown in Figure 7, open Accessory Ring holder by gently prying locking
mechanism up with finger.
1
Lens Head Assembly
Accessory Ring Locking Mechanism
(do not use tools to unlock - open by hand only)
Accessory Ring (closed)
Barndoor*
2
OR
Filter Holder*
Accessory Ring (opened)
Note: *Accessories sold separately.
Figure 7: PL1 LED Accessory Installation
Step 3. Make sure accessory is positioned as desired (in correct slot in holder) and gently slide accessory into
Accessory Ring holder.
Step 4. Swing Accessory Ring holder closed until it locks (snaps) into place.
Step 5. The luminaire is ready for use.
Accessories 33