we keep things moving - STÃBER ANTRIEBSTECHNIK GmbH + Co ...
we keep things moving - STÃBER ANTRIEBSTECHNIK GmbH + Co ... we keep things moving - STÃBER ANTRIEBSTECHNIK GmbH + Co ...
Mounting Operation manual 3 6 Insert the option PCB in the inverter so that the gold contacts slide into the black terminal block: 7 Secure the plate to the inverter with the mounting screws: You have installed the accessory. WE KEEP THINGS MOVING ID 441687.03 12
Mounting Operation manual 3 3.2 Installation in the FDS 5000 WARNING! Danger of injury/death and property damage due to electric shock! Before installing accessories, turn off all voltage supplies! Then wait 5 minutes for the DC link capacitors to discharge. Never begin with accessory installation until after this! CAUTION! Danger of property damage due to electrostatic discharge, among others! Provide suitable protective measures while handling open PCBs (e.g., ESD clothing, environment free of dirt and grease). Do not touch the gold contact surfaces. You will need the following tools to install the DP 5000: • TX10 Torx screwdriver • Pliers • Hexagon socket wrench, 4.5 mm Installing the DP 5000 in an FDS 5000 1 Unscrew the mounting screws and remove the cover plate: 2 Remove the punched out metal section with the pliers: WE KEEP THINGS MOVING ID 441687.03 13
- Page 1 and 2: PROFIBUS Operation manual Fundament
- Page 3 and 4: Table of contents Operation manual
- Page 5 and 6: Introduction Operation manual 1 You
- Page 7 and 8: Notes on Safety Operation manual 2
- Page 9 and 10: Notes on Safety Operation manual 2
- Page 11: Mounting Operation manual 3 2 Remov
- Page 15 and 16: Mounting Operation manual 3 7 Secur
- Page 17 and 18: Electrical installation Operation m
- Page 19 and 20: Fundamentals of PROFIBUS Operation
- Page 21 and 22: Fundamentals of PROFIBUS Operation
- Page 23 and 24: Bus diagnosis/LEDs Operation manual
- Page 25 and 26: Configuration of the bus system Ope
- Page 27 and 28: Configuration of the bus system Ope
- Page 29 and 30: Prozess data transmission PZD Opera
- Page 31 and 32: Control with control and status bit
- Page 33 and 34: Parameter Overview Operation manual
- Page 35 and 36: Parameter Overview Operation manual
- Page 37 and 38: Parameter Overview Operation manual
- Page 39 and 40: Parameter Overview Operation manual
- Page 41 and 42: Appendix A Operation manual 12 12 A
- Page 43 and 44: Appendix A Operation manual 12 •
- Page 45 and 46: Appendix A Operation manual 12 Erro
- Page 47 and 48: Appendix A Operation manual 12 12.3
- Page 49 and 50: Appendix A Operation manual 12 DPV1
- Page 51 and 52: SPM Appendix B PKW0 telegram Operat
- Page 53 and 54: Appendix B PKW0 telegram Operation
- Page 55 and 56: Global Presence Address registers A
Mounting<br />
Operation manual<br />
3<br />
6 Insert the option PCB in the inverter so that the gold contacts slide into the<br />
black terminal block:<br />
7 Secure the plate to the inverter with the mounting screws:<br />
<br />
You have installed the accessory.<br />
WE KEEP THINGS MOVING<br />
ID 441687.03<br />
12