In System Programming (ISP) for ATMEL chips

More documents

Recommendations

Info

In System Programmer (ISP) for ATMEL micro controllers http://www.ikalogic.com/isp.php Page 6 of 29 26-02-2008 1- Connecting the programmer to an ATMEGA16L Note that with the ATMEGA AVR family, You don't need to add a crystal resonator, as those chips contains an internal resonator, making it ready to use simply by connecting the 5V and GND supply rails.
In System Programmer (ISP) for ATMEL micro controllers http://www.ikalogic.com/isp.php Page 7 of 29 26-02-2008 The programmer software This is the piece of software that will take the HEX file generated by whatever compiler you are using, and send it - with respect to the very specific ISP transfer protocol - to the micro controller. The software I am proposing was designed to be compatible with a multitude of ISP programming cables. in most of cases, all the difference is the pins used on the parallel port to perform the data transfer. The only thing you need to do is to go through 'Setup', and chose the 'AEC ISP' cable pinout. once chosen, you will notice that it matches the circuit on this page. If you have more than one parallel port (never seen this a lot..) chose the one to which the programmer is connected. The link to download the software is at the end of
Page 1 and 2: In System Programmer (ISP) for ATME
Page 5: In System Programmer (ISP) for ATME
Page 29: In System Programmer (ISP) for ATME

In System Programming (ISP) for ATMEL chips

Create successful ePaper yourself

Delete template?

Save as template?