Design Of Digital Circuits - Dharmsinh Desai University
Design Of Digital Circuits - Dharmsinh Desai University
Design Of Digital Circuits - Dharmsinh Desai University
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Design</strong> <strong>Of</strong> <strong>Digital</strong> <strong>Circuits</strong> Lab Manual<br />
<br />
GRAY CODE TO BINARY CONVERTOR<br />
Fig:5.2 GRAY CODE TO BINARY CONVERTOR<br />
3.3 Implementing the Solution<br />
Plug the chips you will be using into the breadboard. Point all the chips in the same direction with pin<br />
1 at the upper-left corner. (Pin 1 is often identified by a dot or a notch next to it on the chip package).<br />
Connect +5V and GND pins of each chip to the power and ground bus strips on the breadboard.<br />
Make the connections as per the circuit diagram.<br />
Switch on VCC and apply various combinations of input according to truth table.<br />
In the case of binary to gray conversion, the inputs B0, B1, B2 and B3 are given at respective pins<br />
and outputs G0, G1, G2, G3 are taken for all the 16 combinations of the input.<br />
In the case of gray to binary conversion, the inputs G0, G1, G2 and G3 are given at respective pins<br />
and outputs B0, B1, B2, and B3 are taken for all the 16 combinations of inputs.<br />
The values of the outputs are tabulated.<br />
Department of Information Technology, Faculty of Technology, D. D. <strong>University</strong>, Nadiad.<br />
23
Change language