FlexFrame Specification Guide - Steelcase

FlexFrame
Shelves, Bins, and Drawers, continued
.
A drawer can be placed
directly above another
drawer.
Connections
Shelves, bins, and
drawers attach to metal
brackets through the bottom
of the unit using four screws.
The screws will be visible
when the shelf, bin, or
drawer is above eye level.
Shelves, bins, and
drawers attach to the
workwall frame securely and
cannot be dislodged.
Shelves, bins, and
drawers can be reconfigured
with simple tools. The
reconfiguration can be done
without damaging the shelf,
bin, drawer, frame, or wall.
Wiring and Cabling
Surface Materials
Shelves, Bins, and
Drawers
• Low-Pressure Laminate
3 /4"
• Wood
Blades
• Paint
Pull
• Paint
Wire management cut-
Wire Cut-out Cover
outs allow cord heads and
• Paint
connectors to pass through.
A 3 /4" space between back
Tip: Grain direction on wood
edge of shelf, bin, or drawer
bin and drawer fronts runs
allows for cable and cord
horizontally. Grain direction
passage.
on directional laminate
fronts runs vertically.
Skins are aligned at the
front of the frame allowing
2 1 /2" behind the skin for
routing of cables. This will
conceal the wire management
cut-out. The wire management
cut-out is still
usable for vertical routing of
cables and cords behind the
skins.
A wire cut-out cover
fills the wire management
cut-out.
When skins are used the
wire management cut-out
will be concealed but still
usable.
Tip: Wire cut-out cover is not
needed when skins conceal
wire management cut-out.
.
.
.
.
.
38 FlexFrame Specification Guide
November 2010