SERVICE MANUAL - Stag ICP AG

More documents

Recommendations

Info

Open the door. Disassemble the clamp assembly. Tilt the cabinet cover. Disconnect the door switch connector. NOTE: When assembling the CABINET COVER, connect the connector. Lift and separate the cabinet cover. Disassemble the clamp assembly. Disassemble the Gasket. 33
Open the door. Unscrew the 7 screws from the HINGE COVER. Put a flat ( - ) screwdriver into the openng of the hinge, and pull out the hinge cover. Unscrew a screw from the lower side of door. Disassemble the door upward. Be careful! The door is heavy. Open the door and disassemble the CLAMP ASSEMBLY. Unscrew the 2 screws. NOTE • Reconnect the connector after replacing the DOOR SWITCH ASSEMBLY. 34
Page 1 and 2: Website: http: //www.LGEservice.com
Page 3 and 4: CONTENTS 1. SPECIFICATIONS ........
Page 5 and 6: 2. FEATURES & TECHNICAL EXPLANATION
Page 7 and 8: 2-5. THE DOOR CAN NOT BE OPENED Whi
Page 9 and 10: 4. INSTALLATION & TEST Before servi
Page 11 and 12: TEST OPERATION Preparation for Pres
Page 13 and 14: 6. OPERATION • Use this button to
Page 15 and 16: 7. TROUBLESHOOTING 7-1. BEFORE PERF
Page 17 and 18: ERROR SYMPTOM CAUSE 8 OVER CURRENT
Page 19 and 20: SYMPTOM GUIDE FOR SERVICE CALL Door
Page 21 and 22: 8-2. FAULT DIAGNOSIS AND TROUBLESHO
Page 23 and 24: If it still has severe vibration an
Page 25 and 26: LIQUID DETERGENT/SOFTENER DOES NOT
Page 27 and 28: WASH HEATER TROUBLE 220-240V AC 220
Page 29 and 30: SPIN TROUBLE Rinse Spin Check durin
Page 31 and 32: Disconnect the POWER connector and
Page 33: Unscrew the a screw from the Top Br
Page 37 and 38: Disassemble the cabinet cover. Sepa
Page 39 and 40: 10. EXPLODED VIEW 10-1. CABINET & C
Page 41: 10-3. DISPENSER ASSEMBLY HOT (RED)

SERVICE MANUAL - Stag ICP AG

Create successful ePaper yourself

Delete template?

Save as template?