You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Model VM88 Owner’s <strong>Manual</strong><br />
* Battery check menu<br />
This lets you check the voltage of the internal battery. After selecting this menu item, press the ENTER<br />
key. The voltage of the internal battery will be displayed, allowing you to check it.<br />
When you have checked the voltage, press the EXIT key to exit Setup mode.<br />
<br />
The life of the internal battery is approximately two years. When the battery runs down and the<br />
voltage decreases to a certain level, a warning message of [Batt Empty] will appear in the display when<br />
the VM88 is powered-on.<br />
<br />
It is not possible for the user to replace the internal battery. Please contact a nearest <strong>Fostex</strong> Service<br />
Station. For details on the [Batt Empty] message, refer to page 8 “Before Operation.”<br />
The Options<br />
Multi-purpose clamper can be installed on bottom of VM88. By using the clamper, the VM88 can be<br />
mounted on a pipe mic stand.<br />
To install the clamper, use the four screws provided on the bottom of the VM88, as indicated by<br />
arrows in schematic below. Do not use the screws included with the clamper as the screw pitch is<br />
different.<br />
Location for installing the clamper.<br />
< NOTE ><br />
Remove the four screws (arrows in left schematic)<br />
from the bottom of the VM88 with a screwdriver<br />
and using these screws, securely attach the clamper<br />
to bottom of the VM88.<br />
For safety’s sake when using the clamper, carefully<br />
read its operating manual.<br />
(*) Specific clamper:<br />
As of December 1999, the Roland Model APC-33 is<br />
the most suitable.<br />
38
Change language