MP2600iec Hardware Manual

More documents

Recommendations

Info

4.6 Analog I/O 4.6.2 Analog Output 4.6.2 Analog Output Item Specification Analog output range -10V ~ +10V Number of output channels 1 Electrical isolation None Maximum load current ± 5mA Resolution 16 bit Accuracy 25°C ±0.45% (± 45mV) 0 ~ 55°C ±0.60% (± 60mV) Output delay time less than 1ms CN13 Connector +15 V - + -15V 1 26 AO AO_GND Analog Output Circuit 20
5.1 Switch Settings 5 DIP Switches 5.1 Switch Settings STOP SUP INT CNFG EINIT DHCP NO S11 Switch Name Setting Operating Mode Setting for Normal Operation Details 1 STOP 2 SUP 3 INIT 4 CNFG 5 E-INIT 6 DHCP ON OFF ON OFF ON OFF ON OFF ON OFF ON OFF User program execution inhibited OFF Inhibits user program execution Normal operation Firmware programming mode Normal operation SRAM/clock initialization and configuration bypass mode Normal operation Normal operation Do not set (reserved for future use) Force Ethernet address setting for Port A to 192.168.1.1 and Port B to 192.168.2.1 Normal Operation DHCP-configured IP settings <strong>Manual</strong>ly-configured IP settings OFF OFF ON OFF OFF Enables controller firmware programming. (See Section 11) Set to ON to bypass the stored configuration (e.g. in case of a configuration problem that prevents controller startup) or to initialize the SRAM contents and clock settings after backup power has been lost (See Section 7.1). Always set to ON Enables use of the default Ethernet addresses Enables use of DHCP for IP setting configuration 21
Page 1: MP2600iec Hardware Manual
Page 4 and 5: Table of Contents 8 Ethernet 8.1 Co
Page 6 and 7: 1.2 MP2600iec Appearance 1.2 MP2600
Page 8 and 9: 1.3 Model Number Reference 1.3.2 Ac
Page 10 and 11: 2.2 MP2600iec Hardware Specificatio
Page 12 and 13: 3.2 Installation Standards 3.2 Inst
Page 14 and 15: 3.3 Dimensions 3.3.1 MP2600iec Cont
Page 16 and 17: 4.2 CN13 Connection Description 4.2
Page 18 and 19: 4.4 Controller Digital I/O 4.4.1 In
Page 20 and 21: 4.5 Sigma-5 I/O 4.4.2 Outputs 4.5 S
Page 24 and 25: 5.1 Switch Settings This page left
Page 26 and 27: 6 LED Outputs This page left intent
Page 28 and 29: 7.1 Battery Installation Battery Ho
Page 30 and 31: 8.3 Ethernet Cable 8.3 Ethernet Cab
Page 32 and 33: 8.4 Ethernet Connection Examples Co
Page 34 and 35: 9.2 CFC-U-MP2B-xx 9.2 CFC-U-MP2B-xx
Page 36 and 37: 9.4 JZSP-CSI02-x-E 9.4 JZSP-CSI02-x
Page 38 and 39: 10 Cable Shielding, Segregation and
Page 40: 11 Firmware Upgrade This page left

MP2600iec Hardware Manual

Create successful ePaper yourself

Delete template?

Save as template?