下载 - 常熟开关制造有限公司

More documents

Recommendations

Info

FWB1 温度报警模块 TEMPERATURE ALARM MODULE d 1 30 L FRG 热传感器 Hest sensor 热传感器型号 heatsensortype B(mm) L(mm) d(mm) FRG-7 12 40 φ7 FRG-9 14 41 φ9 FRG-11 16 42 φ11 FRG-13 18 44 φ13 FRG-17 22 47 φ17 注意事项 MATTERS NEEDINGATTENTION 断路器各种特性由制造厂整定 , 用户在使用中不可随意调整 ; 断路器的额定剩余动作电流、剩余电流动作时间 ( 非延时和延时 ), 用户可根据实际需要进行调整 ( 专业人员进行 ); 在主电路通电状态下 , 对额定剩余动作时间为非延时的断路器 , 手按模拟剩余电流动作试验按钮应立即脱扣。对延时的断路器 , 手按试验按钮且保持所调的延时时间值 , 断路器才脱扣 ; 断路器漏电脱扣后 , 面板上漏电指示按钮向外凸出 ; 带漏电报警单元模块的断路器 , 当发生漏电报警后 , 必须对模块上的复位按钮进行复位 , 断路器漏电保护模块才能正常工作。 Allthe performance of thebreakerhave been setby the company,and it could not be adjusted arbitrarily in use. The rated residual operating current and residual current operatingtime (undelay and delay) of thebreakers can be adjusted by the users according to actual needs(operated byprofessionals). As the main ciruit is energized,For the rated residual operating time of undelayed of the breaker,Press the button of simulating residual current working test should release immediately.For the delayed breaker,only while,press the test button and remain the adjusted delay timevalue,the breaker could release. After the breaker released due to creepage,the creepage indicating button on the panel should be outprotrude. The breaker with creepage alarmunit module must reset the return button when creepage alarmed,and the creepage protection module of the breaker can work as normal. 37
订货须知 ORDERINGNOTICE ( 一 ) 用户务必确认对本产品技术资料已有详细了解 , 并应根据断路器将来使用的场合 , 按 “ 订货规范 ” 表订货。 ( 二 ) 如用户订货时对剩余电流保护参数不作要求 , 本公司按 “ 剩余电流保护出厂整定值 ” 表配置。 ( 三 ) 三相四线 400V/230V 或单相与三相共用的线路 , 应选用四极断路器。 ( 四 ) 建筑物内实施等电位联结的 TN-C-S 和 TN- S 系统 , 且不在电源转换处的 CM1 L四极断路器 , 中性极形式推荐采用 A 型或 D 型。订货规范用户单位 Name 规连 Wiring 相对应剩余电流脱扣器型式的额定剩余动作电流 IΔn Thecorrespondingrated residualoperating current IΔn of the residualcurrent release pattern 附件格 Specification 接剩余电流动作时间 Ratedresidualcurrent operating time Accessories 备 Note 注配电型 Power distribution 电动机保护型 Motorprotection U 型 ( 非延时 ) Type U(non-time-delay) V 型 ( 非延时、延时可调 ) ( 标准型 ) Type V(non-time-delay, time-delayadjustable) (typicaltype) W 型 ( 非延时、延时可调 ) TypeW(non-time-delay, time-delayadjustable) 分励脱扣器 Shuntrelease 欠电压脱扣器 Under-voltage release 漏电报警单元模块 Leakage alarm unitmodule 电动操作机构 Motor operator 手动操作机构 Rotary handle operator ( 请在内填上数值 , □ 内打 √) Ordering from Pleasefillfigures in ,mark √ in □ 订货总数 Order Amount Users should make sure of their detailed acquaintance of the products’ technological materials and make order by the ordering notice in termsoffutureapplicablesituations ofthecircuitbreakers. The company would configure by “ Factory’ ssetting values of residual current protection” if users had no requirements of protection parametersofresidualcurrent whenmakingorder. Four poles breakers for the share wire of three-phase four-wire 400V/230V or singe phase and three-phase. The neutral pole type of CM1L four-pole circuit breaker which used in equal potential TN-C-S and TN-S system and not installed power supply changeoverplaceis recommendedtoadopttypeAor type D. 订货日期 Date 板前接线 □ 板后接线 □ 插入式板前接线 □ 插入式板后接线 □ 抽出式板前接线 □ 抽出式板后接线 □ Frontconnected Rear connected Plug-infrontconnected Plug-inrearconnected Draw-out frontconnected Draw-outrear connected VA 型 ( 非延时、延时可调 ) Type VA(non-time-delay, time-delay adjustable) 非延时 Non-time-delay 延时 Time-delay 连接排 □ CM1L - / , In= A, 10In (10A≤In≤630A) 5In □(140A≤In≤630A) CM1L - / , In= A, 12In(10A≤In≤630A) 0.03A □ 0.1A □ 0.3A □ 0.5A □ ( 对 CM1-100、CM1 L L-225) 0.1A □ 0.3A □ 0.5A □ ( 对 CM1L-100、CM1L-225、CM1-400) L 0.3A □ 0.5A □ 1A □ ( 对 CM1L-630) 0.3A □ 1A □ 3A □ 10A □ ( 对 CM1L-100、CM1L-225) 1A □ 3A □ 10A □ 30A □ ( 对 CM1L-400、CM1L-630) 0.1A □ 0.3A □ 0.5A □ ( 对 CM1L-100、CM1L-225、CM1L-400) 0.3A □ 0.5A □ 1A □ ( 对 CM1L-630) □ 2IΔn 时极限不驱动时间 Δt Connecting bar Maximum breaktime of 5IΔn 时最大断开时间 Maximum breaktime of5I Δn 相对应 IΔn 时最大断开时间 Maximum breaktime correspondswithIΔn 相对应 2IΔn 时最大断开时间 Maximum breaktime correspondswith 2IΔn AC400V□ AC230V□ DC220V□ C 型 AC230V□ AC400V□ AC230V□ AC230V□ AC110V□ DC220V□ DC110V□ DC24V□ CZL-F□ Δ t AC400V□ CZL-A □ 0.1s□ 0.25s DC24V□ FWB1 温度报警模块 □ 和热传感器型号 Type FRG-7 FRG-9 FRG-13 FRG-11FRG-17 Temperaturealarm module 数量 Number V 型剩余电流脱扣器为标准型 , 订货时不必注明。 Type Vresidualrelease isstandardtype,it'sunnecessary to note while ordering. 0.5s 0.35s 0.5s□ 0.9s 1.15s 1s 1s□ 1.9s 2.15s 零飞弧罩 □ ( 仅 CM1L-100、 225、 400具有 ) Zerdarcventing cover (only forCM1L-100、225、400) 2s 38
Page 1 and 2: S CM1 L 系列带剩余电流
Page 3 and 4: 公司简介 Introduction 常
Page 5 and 6: 常熟开关制造有限公
Page 7 and 8: 目录 R 概述 1 型号及含
Page 9 and 10: 型号及含义、分类 TYP
Page 11 and 12: 结构简介 SYNOPSIS OF STRUCTU
Page 13 and 14: 四极断路器规格 SPECIFI
Page 15 and 16: 主要技术指标 MAIN TECHNI
Page 17 and 18: 断路器特性曲线 CHARACT
Page 19 and 20: 断路器特性曲线 CHARACT
Page 21 and 22: 剩余电流保护特性曲
Page 23 and 24: 外形尺寸及安装尺寸
Page 31 and 32: 内外部附件 INTERNAL/EXTERN
Page 41 and 42: 不同额定电流的连接
Page 43: FWB1 温度报警模块 TEMPER
Page 47 and 48: 全国一级经销商明细

下载 - 常熟开关制造有限公司

Create successful ePaper yourself

Delete template?

Save as template?