ATEM Switchers Manual - Holdan.eu
ATEM Switchers Manual - Holdan.eu
ATEM Switchers Manual - Holdan.eu
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
70<br />
Operating Your <strong>ATEM</strong> Switcher<br />
To perform a DVE transition on the software control panel<br />
Step 1. On the preview bus, select the video source that you want on the program output.<br />
Step 2. Select the DVE transition style in the transition control block.<br />
Step 3. Expand the transition palette and select DVE from the transition types bar.<br />
If the DVE is being used in an upstream key, the DVE transition style button will be unavailable<br />
for selection until the key is taken off air and off next transition. Refer to sharing DVE resources<br />
below for more information.<br />
Step 4. Use the settings in the DVE palette to customise the transition.<br />
Step 5. Perform the transition as an auto transition or manual transition from the transition control<br />
block.<br />
To perform a DVE transition on the broadcast panel<br />
Step 1. On the preview bus, select the video source that you want on the program output.<br />
Step 2. On the <strong>ATEM</strong> 2 M/E Broadcast Panel, press the DVE button which illuminates yellow. On the<br />
<strong>ATEM</strong> 1 M/E Broadcast Panel, press the SHIFT and WIPE/DVE buttons to select the DVE transition<br />
type. The WIPE/DVE button illuminates green to indicate the DVE transition type is selected. The<br />
system control automatically navigates to the DVE pattern menu. To manually navigate to the DVE<br />
pattern menu press HOME > TRANS > DVE PATTRN.<br />
If the DVE is already being used in an upstream key, the message DVE unavailable will be<br />
displayed and the DVE transition type will not be available for selection until the key is taken<br />
off air and off next transition. Refer to sharing DVE resources below for more information.<br />
Step 3. Use the system control menu buttons to select the DVE effects, graphic effects and to enable/<br />
disable the DVE Key.<br />
Step 4. Use the knobs and buttons in the system control to customize the DVE transition.<br />
You can also enter a DVE rate duration using the number pad followed by the set rate button.<br />
Step 5. If you are performing a graphic DVE, use the select bus to select the logo fill source. Then press<br />
the DEST SHIFT or CUT/FILL button, depending upon your model of broadcast panel, and use<br />
the select bus to select the logo cut source.<br />
Step 6. Perform the transition as an auto transition or manual transition from the transition control block.<br />
DVE Transition Settings
Change language