ATEM Switchers Manual - Holdan.eu
ATEM Switchers Manual - Holdan.eu
ATEM Switchers Manual - Holdan.eu
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
62<br />
Operating Your <strong>ATEM</strong> Switcher<br />
Auto Transitions<br />
An auto transition allows you to automatically transition between program and preview sources at a<br />
predetermined rate. Any upstream keys that were selected in the next transition and any downstream keys<br />
that were tied to the transition control will also change state. Auto transitions are performed using the auto<br />
button in the transition control block. Mix, dip, wipe, DVE and stinger transitions can all be performed as an<br />
AUTO transition.<br />
To perform an auto transition on the software control panel<br />
Step 1. On the preview bus, select the video source that you want on the program output.<br />
Step 2. Select the transition type using the TRANSITION STYLE buttons in the transition control block.<br />
Step 3. In the transition palette, select the settings tab for the same transition type as the transition control<br />
block.<br />
Step 4. Set the transition rate and adjust any other parameter for the transition as needed.<br />
Step 5. Press the AUTO button in the transition control block to initiate the transition.<br />
Step 6. During the transition, the red and green buttons on the program and preview buses both turn red<br />
to indicate that you are in the middle of a transition. The virtual fader bar automatically follows<br />
the progress of the transition and the rate display updates to indicate the number of frames<br />
remaining as the transition progresses.<br />
Step 7. At the end of the transition, sources selected on the program and preview buses are exchanged<br />
to indicate that the video source that was on preview is now on program and vice versa.