ATEM Switchers Manual - Holdan.eu
ATEM Switchers Manual - Holdan.eu
ATEM Switchers Manual - Holdan.eu
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
51<br />
Using the <strong>ATEM</strong> 2 M/E Broadcast Panel<br />
Preview Bus<br />
The preview bus is used to select a source on the preview output. This source is sent to program when the<br />
next transition occurs. The selected source is indicated by a button that is illuminated green. A blinking<br />
green button indicates that the shifted source is on preview. Pressing the SHIFT button will display the<br />
shifted source.<br />
SHIFT<br />
The SHIFT button provides a global shift and is used to shift the program, preview and select busses along<br />
with source labels. It also provides a shift for the transition type and joystick and other menu functions.<br />
Double-pressing buttons in the preview, select and destination busses, as well as the transiton style<br />
buttons, is the same as shift-selecting them and can be a faster way to shift-select buttons. Double-pressing<br />
is not implemented for the program bus as it would cause the program output to momentarily show the<br />
wrong source.<br />
<strong>ATEM</strong> Mix Effects<br />
Destination Bus and Select Bus<br />
The destination bus gives you 1 key access to make changes to sources in your cuts and fills, borders and<br />
dip colors, stinger fills and cuts, DVE logos and cuts, and down stream fills and cuts. To assign a source to<br />
one of these destinations, select any destination in the Destination bus and make your source selection in<br />
the Select bus below it.<br />
The destination bus works in conjunction with the source names display and select bus to assign sources to<br />
auxiliary outputs and keyers.<br />
The source names display and select bus together show you the routing of sources to keys and auxiliary<br />
outputs. The currently selected source is indicated by an illuminated button. A blinking button indicates a<br />
shifted source. A green illuminated button identifies a protected source. Protected sources are program,<br />
preview, clean feed 1 and clean feed 2.<br />
DEST SHIFT<br />
To access the shifted destinations in the destination bus, hold down the DEST SHIFT button at the right side<br />
of the bus and make your selection.<br />
CUT/KEY<br />
When a key setup menu is selected and a CUT/KEY button is pressed, the select bus changes to show<br />
the currently selected cut signal (also known as the Key signal) for that key. When selecting sources for<br />
auxiliary outputs, pressing the two SHIFT buttons displays program, preview, clean feed 1 and clean feed 2<br />
as sources for selection on the select bus.
Change language