ATEM Switchers Manual - Holdan.eu
ATEM Switchers Manual - Holdan.eu
ATEM Switchers Manual - Holdan.eu
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
1<br />
2 3<br />
4 5 6<br />
46<br />
7 8 9<br />
Using the <strong>ATEM</strong> 1 M/E Broadcast Panel<br />
0 CLR<br />
CAM<br />
CUT<br />
FILL<br />
ON ON ON ON<br />
BKGD KEY 1 KEY 2 KEY 3 KEY 4<br />
DIP<br />
MIX<br />
DVE<br />
WIPE<br />
DSK 1<br />
TIE<br />
DSK 2<br />
TIE<br />
AUTO and Transition Rate<br />
The AUTO button will perform the selected transition at the rate specified in the transition rate window.<br />
The transition rate for each transition type is set in the system control, and is displayed in the transition rate<br />
window of the transition control block when the corresponding transition style button is selected.<br />
The AUTO button illuminates red for the duration of the transition and the transition rate display updates to<br />
indicate the number of frames remaining as the transition progresses. If the software control panel is active,<br />
the virtual fader bar updates to provide visual feedback on the progress of the transition.<br />
SHIFT<br />
PREV<br />
TRANS<br />
CUT<br />
AUTO<br />
DSK 1<br />
CUT<br />
DSK 1<br />
AUTO<br />
DSK 2<br />
CUT<br />
DSK 2<br />
AUTO<br />
FTB<br />
Fader Bar and Fader Bar Indicator<br />
The fader bar is used as an alternative to the AUTO button and allows the operator to manually control<br />
the transition. The fader bar Indicator next to the fader bar provides visual feedback on the progress of the<br />
transition.<br />
Transition Control and<br />
Upstream Keyers<br />
The AUTO button illuminates red for the duration of the transition and the transition rate display updates to<br />
indicate the number of frames remaining as the transition progresses. If the software control panel is active,<br />
the virtual fader bar updates to provide visual feedback on the progress of the transition.<br />
Transition Type Buttons<br />
The two transition type buttons allow the operator to select one of five types of transitions; mix, wipe, dip,<br />
DVE, and stinger. Mix and wipe transition types are selected by pressing the appropriately labeled transition<br />
type button.<br />
Dip and DVE transition types are selected by holding down the SHIFT button while pressing the desired<br />
transition type button, or by double-pressing the desired transition type button. The button will illuminate<br />
green indicating a shifted transition type.<br />
The stinger transition type is selected by simultaneously pressing both transition type buttons. When stinger<br />
transitions are selected, both buttons will be illuminated green.<br />
PREV TRANS<br />
The PREV TRANS button enables the preview transition mode allowing the operator to verify a dip, mix,<br />
wipe or DVE transition by performing it on the preview output using the fader bar. Once you press this<br />
button on, you can preview your transition as many times as you like allowing you to make changes and<br />
corrections as needed. You can even preview stinger transitions! Once you are happy with the preview<br />
transtion, press the button off and and you are now ready to send your transtion on air.