ATEM Switchers Manual - Holdan.eu

101
Operating Your ATEM Switcher
Clean Feed 1
Clean Feed 2
This is identical to the program output, however does not include any of the
downstream keyer contents. It’s useful when you want to record a master output
without logos or bugs on the downstream keyers. After selecting the aux you want
to route to on the ATEM 2 M/E Broadcast Panel, simply hold the two shift buttons
and then make the selection on the select bus. On the ATEM 1 M/E Broadcast
Panel, after selecting the aux you want to route to, simply hold the shift button and
cut/fill button and then make the selection on the select bus.
This is the same as above, however this output is taken from between the two
down stream keyers, and so includes down stream keyer 1, but not down stream
keyer 2's output. After selecting the aux you want to route to on the ATEM 2 M/E
Broadcast Panel, simply hold the two shift buttons and then make the selection on
the select bus. On the ATEM 1 M/E Broadcast Panel, after selecting the aux you
want to route to, simply hold the shift button and cut/fill button and then make the
selection on the select bus.
Using clean feeds on aux outputs can allow you to output a local version of a live production with local
broadcast branding from the down stream keyer, but then get a super-less version for International broadcast
from the aux output and clean feed. This is a very powerful feature!
The wife of one of the engineers in the switcher team baked a switcher cake!