Manual - Holdan.eu

1. Either use a 2 nd output from the unit with Output 1, or a distribution
amplifier to generate a 2 nd identical signal. Feed this into RGB1 on the
unit handling Output 2.
2. Go to ‘Adjust outputs’ for Output 2
3. Where ‘Lock [Off] RGB1’ is seen (where RGB1 is the default Lock
source), change the Lock source to ‘OUT1’.
4. Then change the Lock method from ‘Off’ to ‘Genlock’.
12.14 Other setup approaches
The previous setup method relies on your projectors being moved and aligned
to the 190% zoom factor. Other setup approaches are also used where the
zoom factor is adjusted to the projectors’ current position – for instance if they
are already fixed into their final positions.
Assuming your projectors are in fixed positions and you can’t move them, you
will need to adjust the ‘E.blnd’ H-size for both Outputs 1 and 2 to be the same
values such that they overlap, creating the yellow lines mentioned earlier.
You will then need to adjust the zoom values according to the formula given
earlier. For various zoom and output resolutions, the following values for the
edge blending H-size can be used:
Table showing Zoom% values for various Horizontal resolutions and edge
blend H size overlaps.